In-the-hoop projects are very similar in many ways to appliqué embroidery designs done in the hoop. Both have a placement stitching line, to tack down line, followed by detailing and a normally satin stitch outline. Depending upon the design, there may be only one set of placement and tack down lines or there may be a few sets of them-but they are similar. From my experience working in a store, I seen many people avoid appliqué and/or in-the-hoop projects simply because they think they might be too difficult for them. So let's demystify some of those steps.
First, tutorials are included with in-the-hoop projects giving you step-by-step instructions by most if not all digitizers. If you take it one step at a time you would be surprised how simple and fun they can be.The added benefit of an in-the-hoop project is that once it's out of the hoop, generally it is all done. It is a quick way to get a feeling of accomplishment pulling a finished project out of the hoop--great for those of you who do not have a lot of time to sew.
In-the-hoop start off projects with a "placement" stitch. It really does not matter what color of thread you use for the stitch placement. The placement stitch won't show in the completed project because it will be covered by other stitches. It is just a stitch to give you a visual of where to place the material (the instructions will tell you what type of material to place down, i.e., fabric, batting, etc.). The machine will automatically stop allowing you time to put your material down just like it stops for any othercolor change. That is why the digitizer made this placement line a different color-so the machine will know when to stop.
After placing the material over the placement line, the second step is normally to "tack down stitch. The tack down stitch will hold down that material in place so it does not shift. After the tack down is complete, you will want to take the hoop out of the machine but not the material out of the hoop and trim very closely to the stitching. (Again, the color of the thread does not matter as the color change is there so that the machine would know when to stop so you can trim.) Once you have trimmed the material, you will place the hoop back into the machine to complete the design. More often than not, you will be given instructions at some point to wind a bobbinwith matching thread for the top as well as bobbin for a satin stitch which can be seen on both sides.
Depending upon the in-the-hoop project, I like to use to wash away stabilizer. When the machine embroidery design is complete I can either throw it in the wash or use a stencil cutter to melt away the stabilizer giving the satin stitch edge to clean and tidy finish. Tear away stabilizers have a tendency to leave little pokies bits sticking out of stabilizer from the satin stitching when pulled away. (Tip: If this has happened to you, use a "cover up" pen matching the color you used on the satin stitching and color the pokies.)
I would included a free sample Luggage Spotter project for you to try your hand at an in-the-hoop project. It only takes 2, 6 "pieces of fabric, 1, 6"piece of batting, embroidery thread, and an elastic head .25 "wide band (or shoe string) to complete the project. Complete step-by-step instructions with photos are included. Should you have any questions along the way, just write me and I will try to get you past the hump.
Every in-the-hoop project will have some similarities. Some will be more involved than others but they will all have to tack down line placement, stitches, and then your final embroidery detailing.
No comments:
Post a Comment